Step 1. Disconnect the power and LAN cables from the back of your VeraLite and insert a fresh set of 4x AA batteries (the battery compartment is located at the bottom of the device).
Step 2. Press and hold the "Battery" button for 3 seconds, then wait for the blue "Power" light to appear solid. Shortly after, the orange "Ready" light will start blinking once per second indicating that your VeraLite is in include mode.
Step 3. Before adding a device, we recommended that you first exclude it to ensure it's in its factory default state. To exclude a device, you will need to tap the "-" button. The orange "Ready" light will start blinking twice per second. Follow your device's exclude procedure and you will see the "Ready" light flutter briefly as a confirmation that your device was detected and successfully excluded.
Step 4: To include a device, you will need to tap the "+" button. The "Ready" light will blink once per second. Follow your device's include procedure and you will see the "Ready" light flutter briefly as a confirmation that your device was detected and successfully included.
Step 5: Repeat steps 3 & 4 for any other devices you need to add.
Step 6. To save your changes and exit the battery mode, press and hold the "+" button for 5 seconds. You can then plug your VeraLite back into mains power and LAN and proceed to configuring your newly added devices via the Vera GUI.