- Shop
- >
- Z-Wave
- >
- Sensors & Security
- >
- Vision Z-Wave Tilt Sensor
Vision Z-Wave Tilt Sensor
SKU:
A$0.00
Unavailable
per item
DISCONTINUED
The Vision Z-Wave Tilt Sensor is a battery-powered device capable of detecting the horizontal or vertical position of your garage door, allowing you to monitor its state from anywhere using your Z-Wave gateway.
Product Code: RKM-SNS-TS-VIS
Manufacturer: Vision
Model: ZG8101
Sold Out
Vision Z-Wave Tilt Sensor
Product Details
The Vision Tilt Sensor is designed for use with any object whose operation results in a change of vertical/horizontal orientation. Possible uses include:
Powered by a single lithium CR123A battery which can last 3-5 years under normal conditions, this device will emit a visual (LED) warning and send a Z-Wave notification event to your controller, or any associated Z-Wave device, when the battery needs to be replaced. Its small size makes it ideal for a wide variety of uses and for maximum integration possibilities.
- Attached to a panel/tilt garage door to detect when it is opened and closed
- Attached to a letter box door to send an alert when mail is delivered
- Attached to the back of a home theatre chair to dim the lights when reclined
- Attached to the boot of a car to trigger an event when it is opened or closed
- Attached to a tilt style window frame to trigger an alarm if opened by an intruder
Powered by a single lithium CR123A battery which can last 3-5 years under normal conditions, this device will emit a visual (LED) warning and send a Z-Wave notification event to your controller, or any associated Z-Wave device, when the battery needs to be replaced. Its small size makes it ideal for a wide variety of uses and for maximum integration possibilities.
Product Support

User Manual | |
File Size: | 195 kb |
File Type: |
The device also features two additional terminals allowing you to connect an external dry contact input which operates in parallel to its tilt sensing. You can add an external switch or any binary sensor, such as a door/window sensor.
To install an external sensor/switch, loosen the two screws shown below (1). Next, insert the leads from the external switch through the hole in the side of the enclosure (2). Finally, tighten the two screws (1) to secure the leads.
To install an external sensor/switch, loosen the two screws shown below (1). Next, insert the leads from the external switch through the hole in the side of the enclosure (2). Finally, tighten the two screws (1) to secure the leads.
Technical Specifications
- RF Protocol: Z-Wave™
- RF Frequency: 921.42Mhz ‐ AU/NZ approved RF for Z‐Wave
- Application: Indoor use only
- Power: 1 x CR123A Battery
- Operation Range: Up to 30m indoors with no obstacles
- Enclosure Colour: White
- Operating Temperature: -15°C ~ 60°C
- Dimensions: (LxWxH) 74 x 42 x 25mm
- Compliance: EMC 2004/108/EC