Shop
>
Our Brands
>
Fibaro
>
FIBARO Z-Wave Smart Implant

FIBARO Z-Wave Smart Implant

SKU:

A$79.00

A$63.00

Unavailable

per item

The FIBARO Smart Implant allows you to enhance the functionality of appliances, wired sensors, alarm systems, garage doors and more by adding Z-Wave network capabilities to non-Z-Wave enabled devices.

Product Code: RKM-SNS-IMP-FIB
Manufacturer: FIBARO
Model: FGBS-222

Quantity

2 available

Add to Cart

Description

More Info

Support

Description

FIBARO Z-Wave Smart Implant

Add FIBARO Smart Implant to your "dumb" devices and instantly make them smart - with a bit of ingenuity and DIY tinkering, you can add Implant to almost any low-voltage circuit. The possibilities are only limited by your imagination.

Supports Z-Wave network Security Modes: S0 with AES-128 encryption and S2 Authenticated with PRNG-based encryption
Works as a Z-Wave signal repeater
Allows for connecting sensors:
- 6 DS18B20 sensors
- 1 DHT sensor
- 2 2-wire analog sensor
- 2 3-wire analog sensor
- 2 binary sensors
Built-in temperature sensor

This product is compatible with FIBARO Home Center/Lite gateway controllers.

More Info

RF Protocol
Z‐Wave (Multilevel Command Class)

RF Frequency
921.42Mhz ‐ AU/NZ approved RF for Z‐Wave

Z‐Wave Device Type
Z-Wave binary sensor, slave

Power
9 - 30V DC ± 10%

Max. Current of Outputs
150mA

Operation Range
Up to 20m indoors with no obstacles

Application
Indoor use only

Measurement Range
-55C ~ 126°C

Operation Temperature
0 ~ 40 °C

Storage Temperature
‐10 ~ 80 °C

Weight
10g

Regulatory Compliance Mark
RoHS 2011/65/EU RED 2014/53/EU

Dimensions
(LxWxH) 29 x 18 x 13 mm

Support

User Manual

Before installation

Connect only in accordance with one of the wiring diagrams provided in the user manual
The device is powered with secure voltage; nevertheless, the user should be extra careful or should commission the installation to a qualified person
Do not connect devices which are not compliant with the specification
Do not connect other sensors than DS18B20 or DHT22 to SP and SD terminals
Do not connect sensors to SP and SD terminals with wires longer than 3 meters
Do not load the device outputs with a current exceeding 150mA
Every connected device should be compliant with the relevant safety standards
Unused lines should be left insulated

Tips for arranging the antenna

Locate the antenna as far from metal elements as possible (connecting wires, bracket rings, etc.) in order to prevent interferences. Metal surfaces in the direct vicinity of the antenna (e.g. flush mounted metal boxes, metal door frames) may impair signal reception!
Do not cut or shorten the antenna – its length is perfectly matched to the band in which the system operates. Make sure no part of the antenna sticks out of the wall switch box.