- Shop
- >
- Z-Wave
- >
- Lighting Control
- >
- FIBARO Z-Wave Smart Module
FIBARO Z-Wave Smart Module
SKU:
A$109.00
A$83.00
A$83.00
Unavailable
per item
The new FIBARO Smart Module is a smart Z-Wave wireless module which can control a single circuit with a maximum load of 6.5A. With the added benefit of dry-contact support, this device can be used to control low voltage systems such as garden lights and irrigation, or where you want a pure volt-free switch such as alarm panels and garage door controls. Â
Product Code:Â RKM-LIT-SWW-FIB-214
Manufacturer: FIBARO
Model: FGS-214
Product Code:Â RKM-LIT-SWW-FIB-214
Manufacturer: FIBARO
Model: FGS-214
Sold Out
Description
More Info
Support
Description
FIBARO Z-Wave Smart Module
The FIBARO Smart Module (FGS-214) is a smart Z-Wave controller capable of remotely operating your existing light and appliance fittings. It works with Z-Wave enabled controllers (AUS/NZ version) and can be controlled individually or as part of a group in a pre-configured Scene.
The device is designed to operate inside your wall socket and can be easily installed by a qualified electrician. This device requires a 3-wire (including neutral) installation and works with an AC (230V) power supply. |
Fetaures
IMPORTANT: Please check the maximum load before installing or operating. This device must be installed by a certified electrician. For all warranty claims, an electrical compliance certificate from your electrician must be provided.
- Control the ON-OFF function of one circuit or appliance remotely or using a wall switch
- Dry contacts - Can be used to control low voltage systems such as garden lights and irrigation, or where you want a pure volt-free switch such as alarm panels and garage door controls.
- Compatible with all Z-Wave networks
- Acts as a repeater expanding your Z-Wave network
- Wide range of compatibility with existing light fittings and does NOT require expensive cabling
- Z-Wave 500 series chip
- Z-Wave Plus certification
- Very accurate energy measurement +/- 1 % for power above 5W
- Supports secure mode (Z-Wave Network Security) encrypted with AES-128
IMPORTANT: Please check the maximum load before installing or operating. This device must be installed by a certified electrician. For all warranty claims, an electrical compliance certificate from your electrician must be provided.
More Info
RF Protocol
Z‐Wave RF Frequency 921.42Mhz ‐ AU/NZ approved RF for Z‐Wave Z‐Wave Device Type Z-Wave Switch, Routing Slave Power 230V ± 10% 50/60 Hz Operation Range Up to 20 m indoors with no obstacles Application Indoor use only, up to 6.5A load Operation Temperature 0 ~ 55 °C Storage Temperature ‐10 ~ 80 °C Weight 50g Housing ABS Compliance EN 55015, EN 60669-2-1 Regulatory Compliance Mark N5496 Dimensions (LxWxH) 42mm x 37mm x 17mm |
Support