Aeon Labs Z-Wave Home Energy Meter (3 Phase)
SKU:
A$0.00
Unavailable
per item
DISCONTINUED
Installed in an electricity box, the Aeon Labs Z-Wave Home Energy Meter will monitor the total consumption of electricity used by an entire building. And its intelligent clamps will report that energy use back to your Z-Wave gateway or controller, in watts or kilowatt-hours, and in real time. So you can see how much electricity you really use and when you use it.
Product Code: RKM-SNS-HEM-AEO-03
Manufacturer: Aeon Labs
Installed in an electricity box, the Aeon Labs Z-Wave Home Energy Meter will monitor the total consumption of electricity used by an entire building. And its intelligent clamps will report that energy use back to your Z-Wave gateway or controller, in watts or kilowatt-hours, and in real time. So you can see how much electricity you really use and when you use it.
Product Code: RKM-SNS-HEM-AEO-03
Manufacturer: Aeon Labs
Sold Out
Product Details
This is the latest version of Aeotec's Home Energy Meter (HEM) – complete with 3 bigger clamps that are large enough to handle most consumer electrical installations. HEM is designed to hang near your electrical panel and the clamps go around the 1 phase wire coming into your house. The HEM then reports the energy use every few minutes to as often as every few seconds. You can power the HEM with batteries or with the included USB cable. The included USB power cable has bare wires on one end which can be connected to the electrical panel directly.
Features
Note: If installing this device within a metal circuit box, the Z-Wave radio signal strength may be reduced. In this situation it is recommended that the main body of the meter be affixed outside the circuit box. This will improve the radio signal strength. The Home Energy Meter has been weatherised to the international IP43 standard so that it is resistant to rain and snow when placed vertically with the wires protruding from the bottom of the unit.
IMPORTANT: This device must be installed by a certified electrician. For all warranty claims, an electrical compliance certificate from your electrician must be provided.
Features
- Low-cost whole home energy meter(Wattage and kWh)
- Easy installation
- IP43 rated to withstand most weather conditions outdoor
- USB powered or 1 year battery life on 4AA batteries
- Optimized antenna range - 30m (outdoors)
- Firmware up-datable in field by end-consumer
- Certified for USA, EU and AU/NZ markets (FCC, CE, ROHS, C-TICK)
- CT Clamp 1% Accuracy, 200A rating, 24mm
Note: If installing this device within a metal circuit box, the Z-Wave radio signal strength may be reduced. In this situation it is recommended that the main body of the meter be affixed outside the circuit box. This will improve the radio signal strength. The Home Energy Meter has been weatherised to the international IP43 standard so that it is resistant to rain and snow when placed vertically with the wires protruding from the bottom of the unit.
IMPORTANT: This device must be installed by a certified electrician. For all warranty claims, an electrical compliance certificate from your electrician must be provided.
Product Support
Technical Specifications
- RF Protocol: Z-Wave
- Z-Wave Device Type: Z-Wave multiple level, routing slave
- Connections Type: Clamp
- Operating Voltage: USB powered or 1 year battery life on 4AA batteries
- RF Frequency: 921.42Mhz ‐ AU/NZ approved RF for Z-Wave
- Application: Indoor/Outdoor
- Operation Temperature: -10 ~ +40 °C
- Weight: 0.64kg
- Operation Range: Up to 30m when no obstacles
- Wired Interface: USB port for future expansion
- Storage Temperature: -10 ~ 70 °C, humidity 5~95%RH (max)
- Housing: ABS
- Compliance: Certified for USA, EU and AU/NZ markets (FCC, CE, ROHS, C-TICK)